TECHNICAL SPEC
Bulb Size: D1S
Color Temperature: 6000K
Bulb Color: Xenon White
Wattage: 35W
Note：
*Please note some vehicles may not be listed in the compatibility chart,if unsure message us for compatibility or compare to your existing bulbs.
*Only replace for factory HID / xenon bulbs. Do not fit for halogen bulbs or LED bulbs.
*Warranty will be void if bulbs are modified,installed improper,water damage,physical damage,always wear gloves during installation and avoid touching glass, warranty is only covered if the old bulbs are sent back for new ones.
*Do not include the ballast.
Advantage:
1.High brightness, 35W xenon lamp is twice the brightness of the 55W halogen lamp;
2.Power is only 35W, 40% more energy saving than traditional halogen lamps;
3.Efficient environmental protection, long life, is 10 times that of halogen lamps;
4.The applicable voltage range is wide, and it can be maintained in low battery voltage;
5.Applicable to various high and low temperature and wet environments;
6.Good shockproof functions avoid light flashing on bumps;
7.Do not produce excess glare, do not cause interference to the driver of the car.
Technical Specification:
Plug Type: H11
Operating Voltage: DC 12V(fit 12V vehicles)
Color Temperature: 6000K White
IP68 rated water and dust seal, over 50000hrs lifetime
Beam Angle: 360 degree
Material: Aviation 6063 aluminum profile
Operating Temperature: -40-80 degree Celsius
Advantage:
*Latest 3570 CSP chip(USA) light source, 2 luminous faces no blind zone
*Engineering beam pattern design throw more light on road evenly at appropriate angle without foggy light
*White light reflect road paint/signs better to show clearer road situation during night driving
*270 degree low beam angle with cut-off line, will not dazzle oncoming traffic
*Built-in constant current CPU, instant full brightness without start-up relay
Package included:
2Pcs Xenon High/Low Beam + 2Pcs LED Foglight Bulbs
Install Caution:
1. As a safety precaution, make sure that the car has had time to cool down properly before starting the installation process.
2. Put the vehicle into park or make sure it is securely in gear.
3. Make sure to have the ignition turned off and the keys removed.
4. Be careful to avoid burns, especially when turning on or off the vehicles lighting.
5. Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the bulbs with your fingers, as this will cause blotting.
6. Fully examine the connection of the contact points, ports and the wires as faulty connections can cause lighting problems.
7. Make certain that the end of the bulb does not come in contact with the interior light shield of the headlight when adjusting the bulb.
8.Please install car headlight dust cover to ensure the normal operation of the lamp.