1969 Hurst Rambler hood pin SCUFF PLATES only.. set of ( 2 )    , I  handmade a few of these because I was unable to find a set for my own SC Rambler ,  I had ( 1) original  and copied it  -  like the original I used 20 gauge SS ,  2-1/2" dia  - hole in center is made for 1/2" hood pins just like the original .  on the back I used 3M two sided tape very strong thin pads , just peel off paper and it sticks very well , I also used a small amount of heat from a  hair-dryer   , tested on my own car the adhesion  is very good and unable to remove by hand .  Original SC Hurst Ramblers came with hood pin scuff plates with NO holes for attaching - they were glued onto hood.