Rocketarium Mega Vortico Rocket Kit

These oddrocs fly straight up while spinning. Then, these oddrocs helicopter down, for a smooth landing.

If you're looking to mix up your rocket fleet, take the Mega Vortico for a spin.

This oddroc kit comes with seven (7) pieces of pre-cut lightweight plywood. Launch lug and motor tube are also included.  Fully illustrated instructions make assembly a breeze. Painting the rocket is optional.  Not for use on windy days. Use a short (1 foot) launch rod.

Dimensions

Diameter : 7.5"

Weight : 0.85oz

Recommended Model Rocket Motors

Estes® C11-0, C11-3, D11-P, D12-0, D12-3, E9-4

Single Use Aerotech® E15-4, E30-4, F32-4

Aerotech® RMS : D9-4, D15-4, E18-4, E28-4, F12-3, F24-4

Challenges:  The Mega Vortico plywood pieces have tabs that slide into the other parts. This helps to make building the rocket easy.

Model Rocket Kits are rated by Skill Level

1 Beginner

2 Intermediate

3 Advanced

4 Expert

5 Master

If you are just starting in the hobby start at the beginner level and move up from there at your own pace.

What is needed to build and fly

All model rockets come in kit form that require assembly.  The materials are primarily cardboard tubes, balsa or plastic fins and nose cone.  Materials will vary by model and are typically specified in the description of each kit. 

Additional supplies will be necessary to build and finish your model rocket kit and may include:

Scissors, Hobby Knife

Ruler

Wood Glue, Model Cement or CA(Super Glue)

Sandpaper

Masking Tape

Finishing Supplies like:

Wood Filler

Sealer/Primer

Paint

Launching Equipment and Supplies like:

Recovery wadding

Launch Pad

Launch Controller

Power supply

Model Rocket Motors and Igniters

A safe place to fly using guidelines from the National Association of Rocketry Safety Code