Achieving symmetrical line rates greater than 168 Mbps over single twisted-pair, Cat 5e/6/7.
- Ethernet Extension: Extend 10/100Base-TX Ethernet well beyond its
328-foot (100-meter) limitation over a single
unshielded twisted pair (UTP), Cat 5e/6/7, or
even coaxial cable.
- Operates Over Twisted Pair: Realize fiber-optic speeds without the expense—
and hassle—of installing new cables or line-ofsite wireless circuits.
- Plug and Play: Set these units up straight out of the box. No
configuration is required. Auto-sensing 10/100
Ethernet ports support full or half duplex operation.
- Multiple Line Rates Supported: Switch-selectable rate mode options optimize
rate and reach for the noise environment, wire
gauge/type and length.
- Transparent LAN Bridging: Bypass network configuration requirements by
transparently passing all higher layer protocols—
including 802.1Q VLAN frames (tagged and
untagged). Data-transmission mechanism is fully
transparent to such IP video compression
schemes as MPEG-4, H.264 and MJPEG.
- Built-In: 4-Port Ethernet Switch
Specifications:
Rate/Reach
• Long Range Asymmetrical:
250 feet: Downstream (DS) 67 Mbps/Upstream
(US) 16 Mbps
10,000 feet: DS 4 Mbps/US 263 kbps
• Long Range Symmetrical:
250 feet: DS 68 Mbps/ US 50 Mbps
10,000 feet: DS 2.5 Mbps/US 1 Mbps
• High Speed Asymmetrical:
250 feet: DS 168 Mbps/US 95 Mbps
3,500 feet: DS 35 Mbps/US 1 Mbps
• High Speed Symmetrical:
250 feet: DS 121 Mbps/US 144 Mbps
3,500 feet: DS 30 Mbps/US 4 Mbps
CopperLink Line Interface
• RJ-45 (pin 4 = ring; pin 5 = tip)
CopperLink Line Modulation: DMT (Discrete Multi-Tone)
Ethernet Interface (x4): 8-position shielded RJ-45. Auto-sensing 10/100BaseTX with half or full duplex operation.
Protocol: Transparent to high layer protocols: supports 802.1Q
VLAN tagged or untagged frames. Transparent to IP
Video schemes: fully transparent to such compression
schemes as MPEG-4, H.264, and MJPEG.
Impulse Noise Protection Modes: Selectable fast and interleave modes
Target SNR Modes: 6 dB & 9 dB
Management: 8-position DIP switch
Monitoring: 8 LEDs display Power, Link, Ethernet 1–4, Remote,
and Local status.
Power Supply: External AC: 100–240 VAC
External DC: -48, -24, or -12 VDC
Compliance: FCC Part 15A, CE Mark, EMC Directive 89/336/EEC,
Low-Voltage Directive 73/23/EEC
Environment: Temperature: 0 to 50°C, Extended Temperature: -40 to 85°C
Humidity: 5 to 95%, non-condensing
Dimensions: 6.22 W x 1.25 H x 4.75 L in.
(15.74 W x 3.18 H x 12.07 L cm)
Weight: 0.4 lbs (181 g)