Specifications:

• Brand New Oxygen Sensor
• Direct Fit
• Correct Connector No cutting or splicing
• Correct wire length : 500 mm
• Downstream Sensor
• as listed per application
• 4 wire configuration
• Built and tested to strict quality control standards

Package Include:

4 x Oxygen Sensor as pictured

Warranty: 3 YEAR

Interchange For Part Number: SG368 250-24360 15672 234-4260 2344260 24594

Built and tested to strict quality control standards

Fit Vehicle:（Please refer to the compatibility table for details）.

Note: 

1. Factory Direct stores ! Support on behalf of the hair, welcome to consult, we 24 hours online!

HOW TO ENSURE THAT YOU ARE BUYING THE CORRECT PART

Enter complete Year, Make, Model, Trim, and Engine Size in eBay Compatibility Chart Located just above the Item Specifics box at the top of the listing page.

**PLEASE NOTE: Some applications are still dependent on other information.

To reveal Important Part Details in the Compatibility Chart be sure to put your mouse over the IMPORTANT PART DETAILS BOX

*SOME SMART PHONES WILL NOT HAVE ACCESS TO THE COMPATIBILITY CHART*

*It is the responsibility of the purchaser to verify complete fitment*

Review Photo below for guidance.

Must know before buying:

1. If you have any problem, you can contact customer service online at any time. We will reply and try to solve the problem for you within 24 hours.

2. If the purchase is wrong, please contact us first. We will return the product or help you find the right product for replacement according to the actual situation!

(the price, quality and function of the oxygen sensor are fully included in our warranty and return policy. However, any labor costs, dealer store costs or damage caused by incorrect installation are not included.)

How do I know the O2 sensor is good or not? 
A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.

Use a 10-mega ohm digital voltmeter. Hook up the voltmeter's red probe to the sensor's signal wire and the black probe to engine ground. (Use back probe method, DO NOT pierce the wire.) For a good sensor, voltage should fluctuate constantly between 0.1 and 0.9 volts after starting the engine for 2 or 3 minutes.

• Goes above range between 0.1 and 0.9 volt
• Remains below 0.5 volts
• Stays fixed at a particular voltage

You're free to choose replacement or refund if our sensor fails to work, in this case.