describe:

DCF receiver with DCF tuned to time signal transmitter WWVB/60KHz. The induction signal is sent to the IC for amplification, demodulation, and then identified by the for mcu, so that the date and time of the timing center are completely consistent.

Below you will find important setup and circuit diagrams.

Technical Specifications

Product number: WVB-0860N-03A

RCCM category: WWVB/60KHz single frequency

PCB size: 25.0x11.5x1.0mm/FR4

size: AR8x60mm/High Q

Nominal frequency: 60KHz±300Hz

Sensitivity: 28±2dB

Receiving IC: CME6005

    • Operating voltage: 1.1...3.3 V

    • Current consumption: 85 µA max

    • Receiving frequency: 60KHz

    • Board size (without ) LxWxH: 22x13.5x1 mm

    • quality: LxØ: 60x10mm

    • for scope of delivery: 1 piece

       ⇒ DCF receiver with

    • connect:

       ⇒ Ground = Pin

       ⇒ Operating Voltage = Pin

       ⇒ data = pin T

       ⇒ Power On/Off = Pin P1

    • Important note:

       ⇒ PIN P1 is an on/off switch and must be set to for logic low.

Note: The single-frequency cannot switch between different frequencies of DCF/WVB/HBG/BPC. The for JJY dual-frequency can switch between the two frequencies of 40K/60K. As a single-frequency , it can only receive signals in this frequency band.

Package Included:

1*Receiver