WELCOME TO SUPERTECH eBay ONLINE STORE
4 Pin 10mm L Shape Corner Connectors for RGB LED Strip to Strip Connector IP65 Solderless Adapter Terminal UK Seller
4 Pin 10mm L Shape Right Angle Corner Connector RGB Led Light Connectors Solderless Adapter Terminal Multicolour Waterproof LED Strip Lights. Hippo-M Solderless RGB LED Strip Connector is designed for 10mm wide 5050 colour changing strip light with 4 Solder pads on FPC. Not only constant voltage 12V/24V types but also IC controlled strip. Flame retardant PC housing with 4 low-resistant copper conductors make it possible to coolly run under 5A current in total. And patent IDC terminal design makes splicing such easy and convenient to both strip-to-wire and strip-to-strip application. The workable LED density is from 30LEDs to 90LEDs per meter.
- Allow user to attach wire according to project requirement. (Wire Colour, Cross Section, length, etc)
- No need stripping wire insulation when splicing flat ribbon cable.
- No need removes surface coating layer of waterproof strip light.
- Good for high density light LED strip, clear cover will not mask light of first LED.
- Gripping LED strip very reliably
Workable LED Strip
Common SMD RGB LED Strip Light
LED Types: SMD5050, SMD3528
LED Quantity Supported: 30~90 LEDs/Meter.
All LED strips listed above have 4 Soldering Pads on 10mm wide FPCB
2. Can always change wire according to project's actual requirements.
3. IDC technology make it possible to connect strip light with red / blue VHB foam tape on the back.
4. Using Polycarbonate & Copper materials, it is not easy to be destroyed.
5. Material added flame retardant.
6. Working voltage is 3~24V and the max current is 5A.
7. More stable, smaller size, bigger current and less fever
Can stick with the glue on the back.
There have two places specially designed to apply stick the glue on the back of connector, it has the effect of fixing the connector without affecting the appearance.
Can be fixed with the screw.
Cut a small triangle at the right angle to make a design that can install screws without occupying extra space. More stable and strong enough.
Installation TIPS
1. Cut the strip straight perfectly, then fully open the clip (up to 90 degrees).
2. Push the strip in until it hits the backing, and pins on the connector make contact, the fully close with nose pliers!
3. Reminder: Just be sure polarity nodes are matched up ?+? to ?+? and ?-? to ?- ?
| ||||||||||