WELCOME TO SUPERTECH eBay ONLINE STORE
6 PIN 12mm RGBWW/RGB+CCT Hippo LED Strip to Wire Connector Unsoldered Snap IP65 UK Seller
6 PIN 12mm RGBWW/RGB+CCT Hippo LED Strip to Wire Connector Unsoldered Snap IP65.
Designed to connect SMD RGBWW (RGB+CCT Dimmable) 6 soldering pad led strip light
Allow user to attach 6 conductor flat wire according to project requirement (Wire Colour, Cross Section, length, etc)
Support big current.
Good for high density light LED strip, do not mask light of first LED.
Gripping LED strip very reliably
Workable LED Strip? LED Types: RGBWW / RGB + Dimmable
? LED Quantity Supported: 30~90 LEDs/Meter.
All LED strip listed above are RGBWW with 6 soldering pads on 12mm wide FPCB
Installation Guides:
Ensure your section of LED light strip is all the contacts are clean.
Peel off the 3M tape around the cutting line area on the back of the LED strip, then insert the LED light strip into clasp side, with the contacts of the led strip sitting ON the pins of the clasp - make sure to match the + side of the strip to the black wire; (Note: No need to peel off the silicone on the surface of led strip around soldering line area.)Close the clasp down with force.
(Insert the same way as above for strip if you want to strip to strip connection)
If you want strip to wire, then wire into the other side. Clip and assemble it by pliers. Press cap down and no more work needed. (Note: No need to strip at the end of Line Wire.)
Checking the connection is successful.
Specification:
| Model | ST1304DJN12XB601 |
| Name | RGBWW / RGB + Dimmable Strip to Power |
| IP | IP65 (Waterproof) |
| Polarity QTY | 6 |
| Pin Pitch | 2.4mm |
| Way of Contact | insulation-piercing contact |