Burnish your decals

Lay your Vinyl Decals on a smooth, hard surface such as a tabletop, wall, or floor. Use a squeegee (application tool) to burnish the transfer tape to the vinyl graphic by rubbing over it with a very hard pressure. Now, flip it over and repeat on the back side. This will adhere the Transfer Tape to the Vinyl Decal well so that the backing paper will remove more easily.

Position and Secure

Eyeball where you want to place your vinyl Decal, or use a measuring tape to determine the correct position. Use painter's tape to tack the vinyl decal in place on the top corners or center of decal. If required, use a bubble level to check that the design is level by placing it on the 1/8" trim line that surrounds your decal. Adjust as necessary. once you have your Vinyl Decal installed on your surface you will not be able to move it to another position, so take the time to double check that your design is level and EXACTLY where you want it to stay!

Flip, Remove, and Roll

Flip the decal up on one end (like opening a door) and carefully peel the Backing Paper off from the hinged edge. Pull the Backing Paper back slowly at a 180-degree angle, using the flat of your hand to push the vinyl down onto the Transfer Tape as you slide the Backing Paper off. Avoid touching the adhesive on the Vinyl Decal if you can. If the decal wants to come with the Backing Paper, simply roll backward a bit and push the decal back down onto the Transfer Tape using the flat edge of your fingers while you pull back.

Once the Backing Paper is removed, slowly roll the Vinyl Decal down on the surface from the hinged edge. Use the Squeegee or the palm of your hand to smooth and secure the decal from the center outward.

Burnish and Peel

Use the squeegee to burnish the Vinyl Decal securely to the surface with the Transfer Tape still in place. Slowly peel back the Transfer Tape form the top down or from the end to center, again at a 180-degree angle, taking care that the Vinyl Decal stays securely on the surface. Once the transfer tape is removed you can squeegee the stripe or decal with the felt end of the squeegee so not to scratch the decal. Air bubbles can be removed with a puncture tool . Lightly spray the graphics with soap and water and clean remove fingerprints with lint free dry cloth.