Product Description:
The control system is mainly used for yachts, fishing boats and other water vehicles throttle and gear control.
The neutral position is done by pulling out the hand levers 30 degree.

• Dual Function Engine Controls:  dual lever, operates both throttle and shift (dual lever for two engines).
• Same Teleflex Morse MT2 MT3 Single Engine Control Replacement
• Pull-out handle disengages shift for throttle only warm-up
• Dual action, throttle and shift in one lever
• Allow to install neutral safety switch that prevents in-gear starting(switch is not included).
• Smooth shitting and throttling
• Built-in friction to avoid throttle creep
• For use with all 33C style and other engine control cables
• It works on all types of boat with outboard, inboard or I/O power, gas or diesel
• Exceeds EN ISO 11547 standards.

Open the throttle step as follows：
1. Remove the lever.
2. Unlock the throttle and pull the flexible shaft.
3. Remove the swivel bracket.
4. Loosen the two (2) hex head screws at the link mechanism and remove the linkage. Make sure that the shift arm engagement teeth position is not changed.
5. Push the throttle arm toward the housing and rotate it 180 degrees until it bounces back. 
6. Use the hex head screw to fasten the connecting rod mechanism to the desired position.
7. Insert the swivel bracket into the appropriate hole.
8. Re-install the push-pull flexible shaft and handle bar.