Iron Man EL Panel Set

With this set you get:

2 pieces of 3cm x 5cm EL Panel for the Iron Man eyes in a choice of colours

A 10cm diameter round White EL Panel for the Arc Reactor

A 2 x AAA battery EL Driver with trigger button switch

2 x 2-way splitters help the panels fit the costume

The suggested setup is:

The driver is held on the body near the chest

One 2-way-splitter comes out and one channel goes off to the round panel acting as the Arc Reactor near the chest

The other channel has a second two-way splitter going off to the helmet to power the 3cm x 5cm EL Panels for the eyes

These EL Panels are NOT See-through so you must design the eye piece to be above or below the actual eye

By having it on a second 2-way-splitter it makes it easier to unplug and remove the helmet - if it all runs off a 3-way-splitter, which it could, it would not be so easy to unplug the head mask

The kit does not include the mask and it's best to put a design over the glowing Arc Reactor - apart from that, the whole kit is ready to use -

 Just plug and play!

A wide selection of other EL Tape, EL Wire, Sequencers, Drivers and helpful EL accessories are available from our ebay store

- - - - - - - - - - - -

This EL Panel comes with a standard EL Wire connector so simply plugs into any EL driver