Tiny Water Resistant 9v Inverter

This listing is for a 9v (with square battery attachment) Driver which will light up to 5 metres of EL Wire or up to 100cm2 of EL Panels/Tapes.

This Driver is available, Without Switch or With Switch. Please note that it does not have a flashing function.

It has two integral screw fixing points on either side of it so it can be fastened down.

It has a water-tight seal all round it including where the wires come in and out of it. Attached in a sensible place it should withstand all types of weather

Dimensions:

Its dimensions are: 29mm x 19mm x 24mm (L x W x H)

The screw fixing tabs stick out 6mm each on the 29mm side and could easily be cut off if not required.

The Connector wire from the 9v square battery attachment to the Driver/Inverter is about 20cm.

Wire from Driver to EL wire connector is 17cm.

*All the EL Wire we supply comes with a connector already attached, so they plug straight into the Driver*

This standard EL Wire connector enables to quickly switch between different coloured wire or add a Splitter so that more than one length of wire can be used on just one Driver as long as the total length of wire is 5 metres or under.

Speaker wire can be used to extend the distance between the inverter and the start of the glowing EL wire .

A wide selection of other EL Tape, EL Wire, Sequencers, Drivers and helpful EL accessories are available from our ebay store

EL wire has lots of different uses.

It looks amazing when decorating the interior and exterior of cars, motorbikes, trailers and karts and can be used in the interior or exterior of the home and can even be threaded into clothes and hats.

It is a cliché to say you are only limited by your imagination but with EL wire it is true!

If you have not seen it before it is like a really long glow stick that lasts over 5,000 hours.

We are sure you will be amazed - feel free to message us with any questions you may have.

SEE HERE FOR OUR SELECTION OF EL WIRE AND RANGE OF INVERTERS