Please note: Your order may not be shipped for 4-15 days after it's paid for. That is our order process time, ALSO please factor in shipping transit time of 3-15 days. This is for in stock items; some items are occasionally on back-order and will be delayed slightly longer. International orders on average take twice as long to be delivered so please understand the extra shipping time if you are out of the USA. Please before leaving Negative / neutral feedback send us a message with the issue. We have been in business for over 18 years and we will be sure to resolve it 100% . We have been trying very hard to obtain a 5 star Detailed Seller Rating. (DSR), please know that we strive for the ultimate 5-star performance and hope you are happy with our transaction.
This "Buy it now" listing is for ONE resistor.
Solves most LED turn signal problems such as hyper flashing, no flashing or burnt out bulb indications.
You Get:
1x pre-wired 6 Ohm, 50 Watt load resistor, and 2 gel filled Splice Taps.
-Connect one across each LED turn signal bulb to simulate filament bulbs.One resistor is required for each turn signal bulb.
Connection Instructions
Using included splice taps, connect one wire to ground and the other wire to the turn/brake wire. You do not have to cut your car's or bikes wiring. Squeeze splice taps. One Load Resistor required for each turn signal bulb. No instructions are included with these kits.
Load Resistors can get very hot so please do not mount directly on plastic!
Make GScreations your #1 place for all your C5/C6/C7/C8 Corvette parts and aftermarket accessories!!
Check out our other items!!
All installation and use of the products purchased from GSCreations, LLC are done at the owners own risk. GSCreations, LLC will not be held responsible for any damage or injury caused by the installation or use of the products purchased here. By using and / or purchasing any product from this Ebay seller (GSCREATIONS01), you agree to the terms above.