10pcs of 6 Ohm, 

50 Watt resistors can be connected across the turn signal bulbs to simulate the load of a regular filament bulb. This will solve LED related turn signal problems such as hyper flashing, no flashing or burned out bulb indications. One resistor is required for each turn signal bulb. Example wiring shown below.

Notes**

These load resistors will get hot in a short period of time, Must mount them on metal surface.

Do not let them get contact with any plastic parts or paint .

Description:

• Can be used with LED turn light of cars
• Aluminum housing
• Excellent heat dissipation
• With 4 inches (10 cm) wire at each end of the resistor
• Power: 50W
• Resistance: 6 ohm
• Dimensions: Approx. 5(L) X 2.8(W) X 1.5(H)cm(1.97 X 1.1 X 0.6 inch)

Package Included:

10 x Resistors as shown