433MHz Wireless Remote Control Receiver for Raspberry Pi / Arduino.

Unlike the cheaper receiver boards, this crystal-controlled shielded low-noise board will easily pickup signals from 30 metres away.

Comes with a 17.3cm wire antenna.

Includes printed download link to our own instruction PDF for Raspberry Pi with code examples.

We show you how to clone signals using a Pi, and play them back. So you can automate 433Mhz remote controls.

• Receive sensitivity of -116dBm
• Operating Frequency: 433.92 MHz
• Power supply voltage input range: 3V-5.5V
• Low power consumption, 3.3V @ 433.92MHz, 6.0mA / 3.3V, the data transfer rate to 10kbps (OOK / Manchester encoded)
• Temperature range: -40-85 ℃

Comes with a useful free GPIO pin reference card for the Pi & practical code examples.

We are not affiliated with the Raspberry Pi Foundation.
Raspberry Pi is a trademark of the Raspberry Pi Foundation.
All rights acknowledged.