With an ultrasonic cutter, you can cut materials that you would normally cut with a cutter or knife, with less force!

By applying ultrasonic vibrations to the blade tip, the friction coefficient between the workpiece and the blade is reduced, increasing cutting efficiency.

The functions of the hand-held switch can be configured. (ON/OFF, operates when PUSH is pressed)

Equipped with a TAF circuit that provides power when cutting is difficult

Switchable between Normal mode and High mode

Cuttable resins and sheet thicknesses (approximate): ・Resin: ABS, PP, PET, Acrylic ・Sheet thickness: 3mm or less ・Cutting speed: For the above 3mm resin, it takes about 3 seconds to cut 1cm. The cutting performance of the above resins will vary depending on ambient temperature, hardness, and other conditions. *Please consult us in advance if you intend to cut other resins, etc.

Oscillation frequency: 40kHz

Power consumption: Maximum 40W

AC adapter: AC100V-240V 50/60Hz 80VA

Output: DC12V 3.3A

Accessories: BDC-200P 1 case (40 blades *including unusable blades with holes), Blade holder ZH04 1 pc, Blade fixing screw HB03 3 pcs, Hex wrench RR02 1 pc, Protector ZH805 1 pc

Circuit protection: Temperature sensor installed inside the handpiece. Monitoring for abnormalities in the drive circuit due to overload.