This listing is for a finished 3D-printed Audi TT MK1 8N Phone Holder Right Vent Mount 17mm Ball.

Required hardware or additional parts (not included):

• An existing car phone holder is intended to fit to the 17mm ball on the front.

Installation notes:

• Installation requires pulling the vent out, fitting this to the back of the vent, and re-fitting the vent; the source notes it is a tight fit.

Designer fitment notes:

• The mount is described as fitting any single vent on the car.
• The source says a Blukar Car Phone Holder, Air Vent Car Phone Mount Cradle for Car was used, and many car phone holders use the same 17mm ball design.

Additional designer information:

• The intended placement is to the right of the steering wheel instead of in the middle of the dashboard.

Included:

single finished physical item.

Material:

3D-printed plastic for the listed application.

Notes:

Compare the photos, source title, and fitment details with your original part before ordering.

Minor surface texture and cosmetic variation can occur with additive manufacturing.

Made in the USA using USA-sourced materials.

Source attribution

Original 3D model: "Audi TT Mk1 8N Phone Holder right vent mount"

Creator/designer: andyhawes

Source: thing:6828846

Thingiverse source ID: 6828846

License: Creative Commons - Attribution