Specification of F4 1S AIO FC /w SPI 2.4GHz Micro Receiver - FrSky D8

• • Item: F4 1S AIO FC 
  • Weight: 3.83g (without antenna and BT2.0 connector)
  • VTX Power: 25mW
  • CPU: STM32F411CEU6 (100MHZ )
  • Six-Axis: MPU6000 (SPI connection)
  • Firmware version: betaflight_4.2.0_STM32F411
  • Receiver: Support External Receiver, SPI Receiver, including Frsky XM/XM+ receiver, Futaba receiver, Crossfire receiver, and DSMX receiver
  • Motor Pin Connecter: 1.25mm Header Pins
  • Mounting hole size: 29mm x 29mm / suitable for almost all kinds of whoop frame

  Specification of ESC

  • Built-in ESC with 5A continuous and peak 6A current
  • Input voltage: 1-2S Lipo
    
  • ESC firmware: S_H_70_REV16_7.HEX 
  • OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
  • Signal support: D-shot150, D- shot300, D-shot600, Oneshot125, Multishot, PWM
  • 4 Indicators: Receiver indicator (Green)/Flight control status indicator (Blue)/Flight control power indicator (Red)/VTX indicator (Pink)

  Diagram for F4 1S AIO FC(No Rx)

  

  

How to Connect the External Rx to the FC
For more convenience to the pilots, we specially design the Plug & Play SPI Frsky Rx for the F4 1S AIO FC(No Rx), no soldering work needed, super easy to install.  

• 
• 
  
• 
  
• 
  
• 1x BetaFPV SPI 2.4GHz Micro Receiver - FrSky

This SPI receiver comes with Plug & Play port, and is specially designed for the BetaFPV F4 1S AIO FC - No Rx and lite 1-2S Brushless FC-NO Rx, no soldering work needed, super easy to install. 

Specification

• Item: SPI Frsky Receiver
• Chip: CC2500
• Weight: 0.43g
• Connection Way: Pin-Connector
• Support Protocol: Frsky D8, Futaba
• Dimensions: 13.5mm*9mm
• Recommended FC:F4 1S AIO FC, Lite 1-2S Brushless FC

This SPI receiver comes with Plug & Play port, and is specially designed for the F4 1S AIO FC(No Rx) and lite 1-2S Brushless FC(NO Rx), no soldering work needed, super easy to install. 

Notice: The default protocol is Frsky D8 (Frsky D16 protocol is not supported).