Includes black banjos, with banjo bolts and copper washers

This listing enables you to spec your own hoses, from 100mm upto 1500mm (1.5m) in length. Please use the "contact seller" section to discuss your requirements in advance, to ensure you get exactly what you need. All hoses are supplied fully swaged with your chosen fittings permanently attached Please provide the total length of the hose required as measured from banjo centre to banjo centre in millimetres, or to the tips of the sealing faces if your lines require anything other than banjos. Banjos are available in 8mm, 10mm, 11mm or 12mm (or their imperial equivalents) and at any angle from straight to 90*. Please get in touch to discuss any other fitting types or coloured banjos The alignment of the fittings in the hose is not required as the fittings can be turned in the hose after they have been built. banjo bolts and copper washers are not included as part of the listing (it creates more variables than the ebay listing can handle), but are available separately on request All hoses are built in house to order by lightenupgrade, authorised hel perfomance manufacturers, using 100% hel stock (nothing but the best!) on occasion, less commonly used fittings may have to be ordered in Hel performance brake hoses. please carefully check the item title and specifics to ensure compatibility, as these hoses will only fit the specified models/years, especially where abs is an option. this kit is NOT suitable for abs models we will always attempt to have your order built & sent out the same working day, but despatch is set at working day to accommodate any potential delays in busy periods .  The difference between winning and losing is a very fine line… On every mile of every race track the importance of high performance precision braking control has been proven. Total feel and response give you the confidence you need on the road. The difference between an average driver and a great driver is those who can control speed and those who cannot. Speed is nothing without control and it's a very fine line - Which is why HEL Performance only supply very fine lines. Each HEL Performance brake line kit is assembled in-house from the finest quality stainless steel fittings swaged directly to hard drawn tensile stainless steel braided hose. With our extensive automotive listings the complete kit will be manufactured to exact specifications, guaranteeing the look, the quality and the performance you demand. HEL Brake line kits eliminate that 'spongy' feeling often found with rubber hoses under extreme braking conditions - the time when performance is needed the most. By replacing the original rubber hoses with our complete system you will remove this sponginess and your braking will deliver new levels of precision. Don't risk using inferior brake lines when you can trust us to improve braking reliability and performance - We use stainless steel in our lines and our fittings. Most competitors use zinc plated fittings which are at risk from corrosion. Choose your colour and click 'add to basket' to order your brake lines. What's Stopping You? What's Included §  Stainless steel braided brake line(s) §  Natural plain stainless steel banjo bolts (if the fittings require them) §  Copper crush washers (if the fittings require them) §  Installation leaflet Lifetime Warranty We offer a no-quibble lifetime warranty on this item. Global Certification All our hoses are tested to extremes in the laboratory, and on the racetrack, where they’re proven time and time again. Our hoses meet and exceed regulatory requirements all over the world, making them road legal anywhere. You can view our impressive collection of certificates and approvals on our certification page. Specifications Line inner material PTFE Line outer material Stainless steel (303/304) and protective PVC cover Fittings material Stainless steel (303/304) Temperature range -70°C to 260°C (-94°F to 500°F) Inside diameter 3.5mm (0.138") Outside diameter 7.5mm (0.295") Maximum working pressure 290 Bar (4206 PSI) Burst pressure 870 Bar (12618 PSI) Minimum bend radius 38mm (1.496")