3d printed Huskie Robo-cut to 20vDewalt, 20vHercules or 20vBauer adapter. This adapter will work with all three of the batteries mentioned.  This will allow you to use your 14.4v tool with the 18v M18.  It will power your tool with 18v so there is a chance that the tool could wear prematurely.  That being said I did look at the motor inside and it is a RS-750SF which from what I found can handle 18v.  I have not seen any problems running the unit at the higher voltage but being it was designed for 14.4v so keep that in mind.   This adapter does fit tight and locks in place.  Please let me know if you have any questions. Will replace the BP-84 lithium battery!  This also works with the crimper that is in the pictures.

Must remove adapter before charging.

Not responsible for tool or battery damage

Do not store in above 100 degrees  example: hot car with sun beating down

For international buyer is responsible for any customs, duty, tariff charges. 

(This does not come with batteries or tools just the adapter)