Tackle3D Pellet Groove Cutters

Easy to use with a non-slip design so the pellets do not spin when you apply pressure during cutting. You will save so much time with one of these in your bag of tricks. Stock up the day before you go fishing by spending half an hour cutting pellets. No more cutting singles on the bank with wet hands!

The two grooves that you have cut will help the pellet to stay on the band for longer.

Also, for those of us with creaky, sore, stiff hands this will make the whole process so much easier. Trust me, I suffer with my hands.

Currently we have 1 version of the cutter that will accommodate 8mm & 10mm Pellets, however, we will be looking to add more variations. You will be able cut up to 9 x 8mm and 7 x 10mm pellets at one time.

How to use the Cutter

• Open Case and insert your pellets of choice.
• Close the case. It will not close all the way and is normal.
• Apply pressure to the case, this will then allow the case to grip to the pellets.
• Take your table knife, slot it into the groove, slide it over the pellets with a little pressure.
• Then, flip the case over and repeat the process. Job done!

It may take a few tries to figure out the correct pressure and how many times you need to run the knife over for the best results. The cutter will come to 2 End Caps for use when stored away in your Box Drawers or Bags.

For myself, I use a small amount of pressure, and I run the knife over the pellets 5 times. This is what works for me with the pellets I use.

Designed & Printed in the United Kingdom to High Standards.