The C25XP is a High-Speed Motion Controller using an Ethernet connection with True Real-Time Functions. It supports Mach3/4 so it can be highly flexible.

This board requires the Ethernet Smooth Stepper.  Here you can see how it is assembled: https://youtu.be/XOrW3flU31U

Connect ANYTHING with Clean and Simple Connections

 

 

 

Highly Expandable:

 

Full of Features

• Ethernet Smooth Stepper Motion Controller not included!!!
• Built-in PWM-Based Speed Control and Two Built-in Electromechanical
Relays with NO and NC positions for spindle control.
• The system monitors:
- E-Stop
- Safety Charge Pump.
• Electromechanical Relay with NO and NC positions for general purpose
(Port_2 16 or 17, jumper-selectable).
• Microcontroller based SCHP (Safety Charge Pump).
• Optoisolated inputs working at 5-24VDC.
• Uses a single +24VDC to power the system. It generates the isolated voltage for the spindle control circuit and +5vdc for circuits using TTL
logic.
• Status LEDs on all input and output connections.
• DIN Rail mountable.
• Open Collector Outputs pins 1, 14, 16, 17 on Port 2.
• Screw-On connections for all terminals.
• Status LEDs for enable.
• The ENABLE Output of the C25XP is now tied to LPT3. So that relay or
breakout boards connected to LPT3 will be enabled/disabled with the
C25XP.
• Available installers and configuration files that configure all the functions
of the board