Snowblower Impeller Modification Kit.

Kit Includes:

4 x Rubber (SB, 1/4” thk) Paddles (2” x 4”)

4 x Metal Straps (3.25”)

8 x Bolts

8 x Lock Nuts

If you have a gap between your impeller and the wall greater than 1/4” then you are not throwing snow as efficiently as you could. Successful installation can increase throwing distance and improve slush removal.

Installation Instructions

Do one at a time.

0-Disconnect spark plug.

1-Use the metal strap as template to locate and drill the holes.

2-Trim the length of strap/paddle, as required.

3-Position the paddle on the impeller and drill the holes. The paddle should be barely touching the impeller housing.

4-Verify clearances and reposition, as required.

5-Install bolts and locknuts to keep the paddle in its optimal position.

Note: You should always do a prejob check of your machine prior to operation.