Gtech Mk2 AirRam On / Off Switch (Replacement PCB).

Full fitting instructions with photos will be sent to the buyer.

This is for a new printed circuit board, new switch, wires and heat shrink tubing for the Mk2 Air Ram

This fault demonstrates itself by either the on/off switch not working at all or becoming very intermittent.

No soldering is required.

To replace

1. disconnect and remove the battery from the vacuum

2. remove the small printed circuit board (PCB) from the vacuum and snip the two connection wires as close to the PCB as possible.

3. Strip around 5mm of insulation from the existing wires on the cleaner

4. Take one vacuum wire and one of the replacement wires, twist the inner wires together

5. Place the two twisted wires in the shrink tube and heat the shrink tube

6. Repeat for second wire.

Cable may vary but everything is brand new including the pcb with new switch.