Bring your 2004 Toyota Sienna out of the dark ages and back into the modern era!
Key fob, car remote, clicker thingy, key bob… We've heard it called just about everything under the sun. No matter what you call it, one thing is certain: life is just a little bit sweeter when you can lock and unlock your car with the push of a button. Let's face it, it's the 21st Century and no one has time to fumble with caveman technology trying to stick a key into a lock to get into their car. Once you receive your new key fob simply program it to your vehicle and you'll be sliding in and out of your car with ease just like the rest of the cool kids.
Notice: Please make sure this button configuration matches with your current working key fob.
Programming Instructions
2004 Toyota Sienna
Obtain all remote transmitters for this vehicle.
1. Start with the key out of the ignition, drivers door is open, all other doors and trunk closed and drivers door is unlocked.
2. Perform these steps within 5 seconds. A. Insert the key into the ignition (Do NOT Turn it) and Pull key out. B. Insert the key into the ignition (Do NOT Turn it) and Pull key out.
3. Perform these steps within 40 seconds. A. Close then open the drivers door. B. Close then open the drivers door. C. Insert the key into the ignition (Do NOT Turn it) and Pull key out.
4. Perform these steps within 40 seconds. A. Close then open the drivers door. B. Close then open the drivers door. C. Insert the key into ignition and leave it in the ignition. D. Close the drivers door. E. Turn the ignition to ON (Do NOT Start or crank engine) then back to OFF. F. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the door locks do not cycle at this point.
6. Perform these steps within 40 seconds. A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds. B. Immediately after letting go of the lock and unlock buttons, Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and then unlock once indicating successful programming. If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted. C. Repeat steps A and B in step 6 for each new remote.