SUBARU GENUINE
38342AA030
RETAINER, DIFFERENTIAL SIDE
New genuine Subaru part in Subaru packaging.
WHAT THIS IS
The carrier that holds the differential side
bearing in the transmission case.
It threads into the case alongside the
differential and bears against the outer race of
the side bearing. Turning it in or out moves the
differential sideways, which is how side bearing
preload and ring-and-pinion backlash are set.
The circular slots around its face are what the
special tool engages to turn it. Mechanics call
it the sundial, for obvious reasons.
WHY IT IS A SERVICE PART
Because the adjustment is destructive to it.
Every time the retainer is turned against a
loaded bearing, the thread and the seating face
take wear. On a transmission that has been
apart more than once, or that has had a
differential failure, the retainer no longer
holds a settled preload and the setting drifts
under load.
The symptom is a whine that changes with
throttle rather than with road speed, or
backlash that will not hold its figure after a
few hundred miles.
IT IS ALSO WHAT BREAKS
On a hard-driven or launched car, this is a
known failure point.
The retainer is the component that reacts the
side load from the differential into the case.
A dropped clutch at high rpm puts that load in
as a shock, and the retainer is what gives
first — which is a good thing, because it is
cheaper than a case.
SOLD INDIVIDUALLY
Subaru specifies two per transmission, one each
side.
This listing is for one. Order two if both are
being replaced, which is usual when a
transmission is being rebuilt.
PART NUMBER
38342AA030.
Subaru used several numbers in the 38342 series
across different gear ratios and transmission
types, and they are not interchangeable. Check
38342AA030 against the parts diagram for your
own transmission, not just the car, before
ordering.
SPECIFICATIONS
Manufacturer : Subaru
Part number : 38342AA030
Description : Retainer, differential
side
Material : Steel
Quantity : 1 (two required per
transmission)
Condition : NEW
Made in : Japan
NOTES
Bearing, O-ring and lock plate are not included.
Fitting requires the transmission to be opened
and the side bearing preload and backlash reset
to the figures in the service manual, using the
correct adjusting tool. This is workshop work.
Shipped from Japan with tracking.