HILTI
HSD-G M6 1/4" x 25
SETTING TOOL
ITEM 243738

New genuine Hilti tool, supplied from Japan.

WHAT A DROP-IN ANCHOR NEEDS
A drop-in anchor is a steel sleeve with an
internal cone. It goes into the hole flush with
the concrete surface, and it only grips once the
cone has been driven down and the sleeve has
expanded against the hole wall.

Drive it too little and the anchor has not
expanded. It will hold under hand pressure, it
will pass a casual look, and it will pull out
under load.

That is why anchors are set with a dedicated
tool rather than a nail punch or a bolt.

HOW THIS ONE WORKS
The tool seats in the anchor and bottoms out at
exactly the right depth. Hammer it until it
stops, and the anchor is set to specification.

Nothing is judged by eye and nothing depends on
how hard the installer hits it.

THE VISUAL MARK
This is the part that matters on an inspected
job.

When the anchor is fully set, the tool leaves a
visible mark on the anchor flange. An inspector,
a foreman or the next trade can look at the
concrete and see which anchors were set and
which were not, without testing them.

An unmarked anchor is an unset anchor.

HAND GUARD
A guard protects the hand holding the tool from
a missed hammer blow.

MANUAL, NOT MACHINE
This is the hand set tool. It is struck with a
hammer.

The machine set equivalents in the HSD-M series
use an SDS-plus or SDS-max shank and are driven
by a rotary hammer. They are different part
numbers.

SIZE
M6 / 1/4 inch, 25 mm anchor length.

For HKD M6x25 and for short HDI-P drop-in
anchors of the same size. Each anchor size needs
its own tool; this one does not set other sizes.

SPECIFICATIONS
Manufacturer     : Hilti
Designation      : HSD-G M6 1/4" x 25
Item number      : 243738
Type             : Manual setting tool,
                   hammer driven
Anchor size      : HKD M6 x 25
Also sets        : HDI-P short drop-in
                   anchors, same size
Features         : Hand guard, set
                   depth stop, flange
                   marking
Condition        : NEW

NOTES
Anchors, hammer and drill bit are not included.

This tool sets one anchor size only.

Shipped from Japan with tracking.