Honda Genuine 28500-RT4-003 Transmission Shift Solenoid

OVERVIEW
Genuine Honda automatic transmission shift control
solenoid, part number 28500-RT4-003. New, made in
Japan.

WHAT IT DOES
The solenoid is an electrically operated valve inside
the transmission. The control unit energises it, the
valve opens, and transmission fluid under pressure is
routed to engage or release a clutch pack.

Every gear change in an automatic is a sequence of
these valves opening and closing in the right order
at the right pressure. The gearbox is hydraulic; the
solenoids are how the electronics reach into it.

HOW THEY FAIL
Two ways, and both are familiar on high-mileage
Honda automatics.

The winding fails or goes out of specification. The
control unit commands the solenoid, nothing moves,
and a shift does not happen or happens at the wrong
pressure. This logs a code - the P0700 series and the
P0750 to P0770 range - and often puts the gearbox
into limp mode, locked in a single gear.

Or the valve sticks. Varnish and clutch material
build up in fluid that has been left too long, the
spool binds in its bore, and the solenoid responds
slowly or not at all. The symptoms are harsher
shifting, a flare between gears, a shudder at light
throttle, or a shift that arrives late.

The second failure mode is why fluid condition
matters so much on these transmissions. A solenoid
in a gearbox full of old fluid will not last.

BEFORE YOU REPLACE IT
Read the stored codes. Honda transmission codes
identify which solenoid the control unit is
complaining about, and fitting the wrong one solves
nothing.

Check the fluid. If it is dark or smells burnt, the
solenoid is a symptom rather than the cause, and
replacing it without addressing the fluid and the
reason it degraded will put you back where you
started.

Honda automatics are specific about fluid. They take
Honda ATF-DW1 and nothing else. A gearbox that has
been filled with a universal fluid will shift badly
regardless of which solenoids are in it.

WHY GENUINE
A solenoid is characterised by its coil resistance
and its flow at a given current. The control unit's
shift pressure maps assume the factory part's
response. An aftermarket solenoid that is
dimensionally identical but electrically different
produces shifts the control unit did not intend.

SPECIFICATIONS
Brand            : Honda (genuine OEM)
Part number      : 28500-RT4-003
Part name        : Shift control solenoid
Country of origin: Japan
Condition        : NEW

FITMENT
Honda list this part across a wide range - Pilot,
Ridgeline, Odyssey, Accord and Crosstour - for model
years roughly 2011 to 2020.

CHECK AGAINST YOUR VIN
Honda use several solenoid part numbers within one
transmission, and they are not interchangeable.
Confirm 28500-RT4-003 against your own VIN through a
Honda parts catalogue, and against the number on the
solenoid you are replacing.

FITTING NOTES
The solenoid is accessed from outside the
transmission case on these gearboxes. Have the
correct quantity of ATF-DW1 on hand for what is lost
during the job.

Fit a new sealing ring and clean the mating face.
Torque the retaining bolts to specification - these
housings are aluminium and strip easily.

Clear the stored codes after fitting. Some models
require a relearn drive cycle before shift quality
settles.

Shipped from Japan with tracking.