无标题文档


27412 Boat Skeg Protect Guard for Mercury Marine 200-300HP Motor


 

27412 Boat Skeg Protect Guard

  •  This Boat Skeg Repair Guard can cover and protect your skeg against damage from ramp dragging, reduce wear and tear from rocks, hidden debris, and submerged objects, also certainly can replace a broken skeg and keep boat balance
  • Skeg Guard Protector fits for Mercury 200 225 250 300 HP 4.6L V8 ProXS Torque Master 4.8” Gearcase, 20" Shaft, 2019-Present Model. Replace OE Number: 27412
  • Strong Durable Material. Made of 18 Gauge Marine Grade 316 Stainless Steel with self-locking hardware and a mirror-polished finish. Comes with Male & Female Stainless Locking Screws, 1/4-inch drill and hex key tools
  • Rational Considerate Engineering. Thickened 3mm lower wear tab reduces ramp dragging. Guard also features a drain hole on the bottom to prevent water from collecting and causing corrosion or freezing
  • Easy Installation. Remain 2-3 Inches of Skeg firstly. Use a rubber mallet, slide the Guard onto the existing skeg and gently tap on it until fully seated. Then use the pre-drilled holes of the guard to drill skeg with a 1/4-inch drill bit supplied with the product, tighten the hardware with the hex key tool  


    •  
                                 
                                 
                                 
                                 

    27412 Boat Skeg Protect Guard

  •  This Boat Skeg Repair Guard can cover and protect your skeg against damage from ramp dragging, reduce wear and tear from rocks, hidden debris, and submerged objects, also certainly can replace a broken skeg and keep boat balance
  • Skeg Guard Protector fits for Mercury 200 225 250 300 HP 4.6L V8 ProXS Torque Master 4.8” Gearcase, 20" Shaft, 2019-Present Model. Replace OE Number: 27412
  • Strong Durable Material. Made of 18 Gauge Marine Grade 316 Stainless Steel with self-locking hardware and a mirror-polished finish. Comes with Male & Female Stainless Locking Screws, 1/4-inch drill and hex key tools
  • Rational Considerate Engineering. Thickened 3mm lower wear tab reduces ramp dragging. Guard also features a drain hole on the bottom to prevent water from collecting and causing corrosion or freezing
  • Easy Installation. Remain 2-3 Inches of Skeg firstly. Use a rubber mallet, slide the Guard onto the existing skeg and gently tap on it until fully seated. Then use the pre-drilled holes of the guard to drill skeg with a 1/4-inch drill bit supplied with the product, tighten the hardware with the hex key tool