Paint And Varnish Remover Stripper Nitromors All Purpose Super Strength 4L

Description:

Remove paint and varnish effectively with the Nitromors All Purpose Paint and Varnish Remover. The high-strength paint and varnish remover effectively strips wood, metal and masonry and features a non-drip gel formula, making it ideal for vertical applications. In addition to the gel technology, there is a green colour indicator to make it easy to see where the remover has been applied. It is easy to use and now features a faster blistering. The paint stripper is water washable, making it easy to clean up after application and removal.

Features:

• The super-strength paint and varnish remover can be used for a wide range of DIY projects both internally and externally
• The Product Benefits at a Glance
• Non-drip gel formula for vertical applications
• Features a colour indicator
• For wood, metal and masonry
• Technology: Gel formula

Preparation: 

Extinguish all ignition sources (fires, boilers, cookers, pilot lights etc.) DO NOT SMOKE • Wear suitable protective gloves and safety goggles. Wherever possible work outside. Otherwise ensure maximum ventilation by opening windows and doors. A fan can be used to assist airflow. Do not use in enclosed spaces. e.g. cellars, floor wells etc. Without adequate ventilation, formation of Highly Flammable and possible explosive vapour concentrations may occur. Protect surrounding areas and items not to be stripped with a polythene sheet. Do not use in direct sunlight. Not suitable for removing paint or contact on plastics & GRP Store container in a cool dry place, do not allow to rust Particularly effective in removing ABS, styrene polymers, rubbers and adhesive elastomers. Not suitable for removing paints applied to these substrates. For use on plastics of unknown composition check compatibility in small inconspicuous area.

How to use:

1. Pour into a suitable container and replace screw cap immediately. Apply a thick coat with a dabbing action (2-3mm) Do not brush out Only apply to areas up to 0.5m2. 
2. Once paint has blistered (5-10mins) apply second coat, working into the blistered paint. Leave up to 40 minutes. If dried out re-apply 
3. Remove blistered and softened paint with a scraper or shavehook. In difficult areas use an old nylon toothbrush. Repeat as necessary. For ingrained paint rub with wire wool dipped in Nitromors. Wash off with detergent in cold water and a nylon Scourer or use white spirit and wire wool to avoid raising the grain on fine or laminated woods. Allow to dry thoroughly and rub down with fine sandpaper or wire wool prior to refinishing.

Please Select Desire Pack From Drop Down Menu:

• Paint & Varnish Remover - 4L
• Shed & Fence Block Brush - 4"/100mm