Clamp Collar Mounting Flange - Point Pod Compatible Pop-Up Outlet Mount | Custom Diameters | Made in USA

The mounting flange the manufacturer doesn't sell. If the black mounting collar for your Point Pod pop-up outlet (PPCV815 / PPCV815B) cracked during installation or removal, you don't have to replace a $679 unit over a plastic part. This is a precision-made compatible replacement - castellated clamp collar, pre-drilled adhesive/screw flange, hose-clamp notches - manufactured in the USA from durable ABS.

How It Works

Seat the flange against the underside of your countertop around the 4" (102mm) hole (adhesive or screws through the pre-drilled holes), slide the outlet body through the collar, thread a standard worm-gear hose clamp through the finger notches, and tighten. The flexible castellated fingers grip the body evenly and hold the outlet at the correct height.

One Part, Dozens of Uses

Any Size You Need — Made to Order in the USA

Every collar is manufactured to order: any diameter from 1" to 12" (25–300mm). Choose a stock size from the dropdown or select Custom Diameter and message us your pipe/tube outside diameter, no tooling charges, no minimums. Contractors and OEMs: ask about bulk pricing.

Specifications

Frequently Asked Questions

What size hole does a Point Pod pop-up outlet need in the countertop?

A Point Pod pop-up outlet requires a 4 inch (102mm) diameter hole. The lower body cylinder measures 3.85" (98mm), the mounting flange needs 6-5/16" (160mm) of under-counter clearance, and the unit needs 18" of cabinet depth.

Can you buy a replacement mounting flange for a Point Pod outlet?

Point Pod does not sell the black mounting flange separately. DC Additive Pros manufactures this compatible replacement for PPCV815 and PPCV815B outlets, made in the USA from ABS. It installs with the original hose clamp or any standard worm-gear clamp.

Can this be used as a raised floor grommet in a data center?

Yes, for mechanically anchoring cable bundles and conduit through raised floor and cabinet openings, in any diameter from 1" to 12". Note it is a clamp collar, not an airflow-sealing grommet, if you need hot/cold aisle air sealing, ask us about a gasketed version.

Is a 3D printed ABS mounting flange strong enough?

Yes. The original equipment flange is also plastic (polyamide/ABS class). This replacement is printed solid-wall in ABS, impact-resistant and heat-tolerant to approximately 176°F (80°C) continuous, well above under-counter conditions.

Can this collar be used for ducting, dust collection, or cable pass-throughs?

Yes. The same clamp-collar design works as a 4" dust collection flange, HVAC starting collar, grow tent duct flange, marine cable gland, blower tube adapter, and pipe mounting collar. Order the diameter matching your hose or pipe outside diameter.

Aftermarket compatible part. Point Pod is a trademark of its respective owner; DC Additive Pros is not affiliated with Point Pod, Lew Electric, or Docking Drawer.