I now place these on all of my tables. I offer these due to the old crummy rubber falling apart. These will never fall
apart. My design also has been thought out very well. The spring turns into the top part, using a counter clockwise turn, until
they bottom out. The bottom part has slightly larger holes, with a special 45 ° chamfer to automatically line up the bottom springs
for easy insertion. And no, they do not fall out.  See video.
I also add a 1.5"  soft touch felt pad to the bottom, this keeps all scratches off of your equipment. There is no flap of cloth to fold either. I cannot offer screws due to the infinite number of sizes and lengths. Use your old hardware, or buy some new screws.
The screw holes will accommodate up to 10-32 diameters.

The springs I sell, with this item, are  .8mm wire diameter, 10mm outer diameter, and 30mm length.  X4 springs. 
These springs cost more than the whole parts do. They are made of 316 Stainless steel.
You will receive 4 complete sets, ready to install. FOR ONE TABLE ONLY.
Each puck is 1.75" diameter, and .5" high. The springs may make a gap of anywhere between 1/8" to 1/2". According to the table weight. Once installed, try not to slide your table around, pick it up first. These will hold up a 16 Lb. table, 5 springs will do 20 Lbs.
Sold 8 sets so far.
Free shipping now folks. :)