• Compatibility
  •  
  • 2007-2013 Chevrolet Avalanche 2014-2019 Chevrolet Suburban 2007-2014 Chevrolet Suburban 1500 2007-2019 Chevrolet Tahoe 2007-2019 GMC Yukon 2015-2018 GMC Yukon XL 2007-2014 GMC Yukon XL 1500
  •  
  • *will not fit models equipped with automatic load-leveling* *will fit 6-lug models only / non-airbag / auto-ride
  • Important: **Aftermarket Uniball UCA is highly recommended on 2019+ models when front lift is higher than 2.5". The upper ball joint will wear out rapidly with use of stock UCA
  •  
  • Front Installation:
  •  
  • Front 2.5 inch & Rear 2 inch Leveling Lift Kit For Chevy Tahoe GMC Yukon 2007-19

    Compatibility

     

    2007-2013 Chevrolet Avalanche
    2014-2019 Chevrolet Suburban
    2007-2014 Chevrolet Suburban 1500
    2007-2019 Chevrolet Tahoe
    2007-2019 GMC Yukon
    2015-2018 GMC Yukon XL
    2007-2014 GMC Yukon XL 1500

     

    *will not fit models equipped with automatic load-leveling*
    *will fit 6-lug models only / non-airbag / auto-ride

    Important:
    **Aftermarket Uniball UCA is highly recommended on 2019+ models when front lift is higher than 2.5". The upper ball joint will wear out rapidly with use of stock UCA

     

    Front Installation:

     

    After removing the wheel, remove any brake line and ABS line brackets, so you have enough slack in the lines.

     

     

    Use a wrench to remove the upper strut mount nuts and the upper ball joint nut. Strike the side of knuckle with a hammer to get the ball joint to separate.

     

     

    Using a wrench, remove the steering linkage nut.

     

     

    Remove the sway bar nut and bushing.

     

     

    Remove the two lower strut mount bolts and remove the strut from the vehicle.

     

     

    Install the supplied bolts into the leveling kit spacer.

    These will act as the new studs when reinstalled.

    Bolt the spacer to the top of the strut using the supplied nuts.

     

     

    Rotate the strut 180 degrees and install it back into the truck. Re-insert the lower strut bolts.

    The lower mount bushing will rotate to correct the angle.

     

     

    Raise the lower control arm to raise the spindle while lowering the upper control arm to re-install the upper ball joint and Re-install the steering linkage.

     

     

    Complete the installation on the other side of the truck before reinstalling the sway bar nut and bushings.

     

     

     

    Rear Installation:

     

    Step 1: Loosen the lug nuts and jack the truck up.

    Step 2: Put jackstands under the frame as far rear and high as possible.

    Step 3: Support the axle with a floor jack under the rear differential.

    Step 4: Remove rear tires.

    Step 5: Unbolt the lower shock bolt.

    Step 6: Unbolt the sway bar from the axle bracket.

    Step 7: Lower the rear axle.

    Step 8: The coils should be loose, but not loose enough to pull out.

    Step 9: Jack up one side of the axle forcing the other side to drop even closer to the ground.

    Step 10: Remove the coil.

    Step 11: Place spacer on top of the lower coil bucket.

    Step 12: Put coil back into place(forcefully)

    Step 13: Repeat on opposite side.

    Step 14: Jack the axle up from the differential to align the shocks and reinstall bolts.

    Step 15: Reinstall the sway bar bolts.

    Step 17: Remove jackstands.

    Step 18: Lower truck to the ground.

    Step 19. Retighten lug nuts.

    Step 20. It is recommended to take your vehicle to an alignment shop to have it realigned.

     

     

     


     



    Payment

    1.We accept multiple payment methods

    2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages.

    3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)

    4.Payment must be received within 10 days as auction ended or order might be delayed.

    Shipping
    1. Orders processed within 24 hours of payment verification.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
    2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address.
    3. The images shown are not the actual item and are for your reference only.
    4. Fast shipping:All our packages use USPS First Class Package Service
    5. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
    Returns

    We stand behind every product we sell.
    All of our brand new items come with a 30-Day money-back or exchange guarantee.

    Feedback
    1. We maintain high standards of excellence (five stars review)and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
    2. It is impossible to address issues if we do not know about them!
    Warranty
    1. 12 months Manufacturer's Warranty for defective items (excluding items damaged and/or misused after receipt). Accessories come with a 3-month warranty.
    2. Defective items must be reported and returned to us within the warranty period (and in the original packaging, if possible). You must tell us what the defect is and give us your eBay ID. we do not repair or replace items with an expired warranty.
     
    You agree to all of the above-listed policies upon bidding on and winning this auction!

    Seller Level
    Weekly Special Sell
    Shop Category
    Front 2.5 inch & Rear 2 inch Leveling Lift Kit For Chevy Tahoe GMC Yukon 2007-19

    Compatibility

     

    2007-2013 Chevrolet Avalanche
    2014-2019 Chevrolet Suburban
    2007-2014 Chevrolet Suburban 1500
    2007-2019 Chevrolet Tahoe
    2007-2019 GMC Yukon
    2015-2018 GMC Yukon XL
    2007-2014 GMC Yukon XL 1500

     

    *will not fit models equipped with automatic load-leveling*
    *will fit 6-lug models only / non-airbag / auto-ride

    Important:
    **Aftermarket Uniball UCA is highly recommended on 2019+ models when front lift is higher than 2.5". The upper ball joint will wear out rapidly with use of stock UCA

     

    Front Installation:

     

    After removing the wheel, remove any brake line and ABS line brackets, so you have enough slack in the lines.

     

     

    Use a wrench to remove the upper strut mount nuts and the upper ball joint nut. Strike the side of knuckle with a hammer to get the ball joint to separate.

     

     

    Using a wrench, remove the steering linkage nut.

     

     

    Remove the sway bar nut and bushing.

     

     

    Remove the two lower strut mount bolts and remove the strut from the vehicle.

     

     

    Install the supplied bolts into the leveling kit spacer.

    These will act as the new studs when reinstalled.

    Bolt the spacer to the top of the strut using the supplied nuts.

     

     

    Rotate the strut 180 degrees and install it back into the truck. Re-insert the lower strut bolts.

    The lower mount bushing will rotate to correct the angle.

     

     

    Raise the lower control arm to raise the spindle while lowering the upper control arm to re-install the upper ball joint and Re-install the steering linkage.

     

     

    Complete the installation on the other side of the truck before reinstalling the sway bar nut and bushings.

     

     

     

    Rear Installation:

     

    Step 1: Loosen the lug nuts and jack the truck up.

    Step 2: Put jackstands under the frame as far rear and high as possible.

    Step 3: Support the axle with a floor jack under the rear differential.

    Step 4: Remove rear tires.

    Step 5: Unbolt the lower shock bolt.

    Step 6: Unbolt the sway bar from the axle bracket.

    Step 7: Lower the rear axle.

    Step 8: The coils should be loose, but not loose enough to pull out.

    Step 9: Jack up one side of the axle forcing the other side to drop even closer to the ground.

    Step 10: Remove the coil.

    Step 11: Place spacer on top of the lower coil bucket.

    Step 12: Put coil back into place(forcefully)

    Step 13: Repeat on opposite side.

    Step 14: Jack the axle up from the differential to align the shocks and reinstall bolts.

    Step 15: Reinstall the sway bar bolts.

    Step 17: Remove jackstands.

    Step 18: Lower truck to the ground.

    Step 19. Retighten lug nuts.

    Step 20. It is recommended to take your vehicle to an alignment shop to have it realigned.

     

     

     


     



    1.We accept multiple payment methods

    2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages.

    3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)

    4.Payment must be received within 10 days as auction ended or order might be delayed.

    1. Orders processed within 24 hours of payment verification.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
    2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address.
    3. The images shown are not the actual item and are for your reference only.
    4. Fast shipping:All our packages use USPS First Class Package Service
    5. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!

    We stand behind every product we sell.
    All of our brand new items come with a 30-Day money-back or exchange guarantee.

    1. We maintain high standards of excellence (five stars review)and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
    2. It is impossible to address issues if we do not know about them!
    1. 12 months Manufacturer's Warranty for defective items (excluding items damaged and/or misused after receipt). Accessories come with a 3-month warranty.
    2. Defective items must be reported and returned to us within the warranty period (and in the original packaging, if possible). You must tell us what the defect is and give us your eBay ID. we do not repair or replace items with an expired warranty.
     
    You agree to all of the above-listed policies upon bidding on and winning this auction!

    Copyright of CCIYU-AutoParts_All rights reserved.