






Dental Lab Device JT-19 Wet Model Trimmer Abrasive Disc Wheel Gypsum Arch 500W
Features:
1. Connect One End of the Water Tube to the Nozzle of the Wet Model Trimmer and the Other End to the Tap, Open the Valve
2. Connect the Waste-disposal Tube to the Unit
3. Connect the Power Cord, and Switch on the Power Switch (O=off, L=on)
4. When Braking, It Is Normal to Hear Clicking Before the Sand Tablet Stops. If the Sand Tablet Makes Unusually Loud Noises, Remove It, and Use the Included Hex-wrench to Adjust the Screw on the Back Cover (18)
5. To Check If You Need to Replace the Abrasive Disk, Rotate the Disk by Hand and Estimate: If the Platform Jumps More than 2mm, Change the Disk. After Replacing the Disk, Make Sure to Tighten the Ring on the Platform 8 (Closest to the Outside of the Sand Tablet)
If There Is some Abnormal Noise When Working on
Possible Reason:① Axon Is Loosing ② Disc Is Not Plain Enough。
How to Solve It:①Dissemble the Disc⒃ with Spanner,Make the Snap
Ring Tightly;② Change the Disc。
The Machine Does Not Work When Power on
Possible Reason:① Fuse Get Burnt;② Motor Get Burnt;③ Switch Get Wrong。
How to Solve It:① Change the Fuse(22) Which Inside the Socket;② Change the Motor ③ Change the Switch
Voltage: 110v/60hz
Power: 500w Rotational Speed: 2800 RPM
Dimensions: 44×35×35cm Weight of the Dental Trimmer: 20kg
Content:
1x Jt-19 Wet Model Trimmer Abrasive Disc Wheel Dental Lab Equipment


| Brand | Unbranded |
|---|---|
| Voltage | 110v/60hz |
| Power | 500w |
| Rotational Speed | 2800 RPM |
| Dimensions | 44×35×35cm |
| Weight of the Dental Trimmer | 20kg |

