Features:ZAPPER Clark. Condition is New.
LCD Display 0,01Hz-700kHz
1. Working voltage: 9V
2. Frequency range: 0,01Hz-700KHz
Compact size, complete functions, simple operation, easy to carry. It can be powered by a power Connector or a 9V battery.
The square wave output is suitable for oscilloscope attenuator and probe pulse characteristic adjustment|.
Have a filter (can be opened and closed) to suit the output of sine wave and pulse wave|.
This functional signal generator can test many kinds of wave forms such as: sine wave, square wave, triangle wave, forward sawtooth wave, reverse sawtooth wave, etc. It is especially designed for those professional worker
https:
Specifications:
Material: ABS
The main technical parameters:
1. Output waveforms: sine wave, square wave, triangle wave, forward sawtooth wave, reverse sawtooth wave, ECG wave, exponential rise, exponential fall, Lorentz pulse, Gauss pulse, Sinc pulse, half-wave, full-wave, Schumann wave, noise wave, etc. 15 kinds of waveforms|.
2. Power supply: DC-9V is recommended when
3. Current: 180MA at voltage 9V
https:
4. Frequency range: sine wave 0.01Hz- 700.00kHz other waveforms 0.01Hz-700.00kHz (but does not limit the upper limit of the adjustable frequency, if the distortion and jitter requirements are not high, the use of frequency can be further increased).
5. Resolution: 0.01Hz.
6. Sine wave distortion: <1% below 1kHz, <0.5% above 1kHz.
7. Output amplitude: Maximum ±10V (P-P).
8. output impedance: 50 ohms
9. DC offset: maximum ±9,5V, with shutdown function.
10. All setup parameters can be saved.
11. there are filters can be turned on and off, can be well adapted to sinusoidal and pulse waveform output.
Package List:
1 * Signal Generator
2 * 9V 1A Power Adapter
3 * BNC Clip Cable
4 * 2 pieces of copper pipes
5 * 9V Battery Clips Black Red Wires Cable Connection
6 * The 9v battery in the picture is not included !!!!!
Do not touch the copper pipes together when the appliance is switched on for a short time so as not to damage the appliance.
Setting up the device for use. Turn on the 9V battery or 9V 1A Power Adapter on the left side of the device 1 Press the red power button 2 From the mode button, select square wave 3 From the 5 green start stop button when you press it the numbers on the screen will flash 4 With the cursor button, set the frequency you selected from 1hz to 700 khz then press the 5 green store button to stop flashing 5 After the set frequency, press the DC offset button to turn on you can use the device.
Notes:
1. There may be slight size deviations due to manual measurement, different measuring methods and tools.
2. The picture may not reflect the actual color of the item because of different photographing light, angle and display monitor.
3.The device is for non-medical purposes.
4.The color of the cables may be different from the picture.
5.Battery 9v is not included in the package.