Product parameters:

The inventory of the 4260 brushless motor with inner rotor, front and rear double ball bearings, rare earth medium strong magnetic inner rotor, built-in drive board, suitable voltage is DC12V-18V, corresponding speed is 6000-10000 rpm, the motor runs very quietly. From the end of its shaft, its positive thread with flat position is probably also a brushless fan motor, and the brushless fan motor does not require very strong torque. The motor direction is CCW.

Motor wire length: over 150 mm

Motor weight: 288 grams

Rotation direction: CCW (axis facing the motor)

Voltage: DC12V

No load current: 0.24 A

Idle speed: 6000 RPM

Voltage: DC14.4V (rated voltage)

No load current: 0.26 A

Idle speed: 7400 RPM

Voltage: DC18V

No load current: 0.35 A

Idle speed: 10000 RPM

The lead wire of the motor is 4P, and the wiring definition is as follows:

Red line: Positive pole of power supply

Blue line: PWM line

Black line: GND (negative pole of power supply+negative pole of PWM)

Green Line: FG

If the motor is simply running, connect the red wire directly to the positive pole and the black wire directly to the negative pole (the blue and blue wires can be left hanging without wiring), and the motor will run at the highest speed.

If PWM speed regulation is required, it can be achieved through the PWM speed regulator in the link. The red wire is connected to the positive pole, the black wire is connected to the negative pole, and the blue wire is connected to the PWM signal.