FENDER PRECISION/JAZZ BASS:
PICK-GUARD,
 16 each WOOD SCREW PACK,
#4 X 3/8",
NICKEL PLATED
BUY IT NOW: Set of 16 EACH #4 x 3/8" NICKEL PLATED, OVAL HEAD, Phillips drive, wood screw kit
Use a piece of tape to "measure approx. 3/8" to 1/2" depth up the drill bit.
Use a Phillips #1 screw driver for a correct fit to head of Phillips screw. 
Locate the pick-guard and tape to body to secure alignment.
Drill and install two screws opposite each other to align the pick-guard and to keep it from "rotating"

                                                                    
                              See other sales on ebay for the Precision set of tuner screws.

             What BuyR's tell me:
 "Exactly what I needed for my new pick-guard AND the pilot drill helped because I could not find the correct size at the local hardware store"
                                       "Exact fit for a pick-guard change on my Fender Precision bass Thank you" 
           
"Included enough screws (16 each) to complete my project.  other seller only sold me 12 or less screws and 
                                                                    I need to purchase a second set"
Seller: wwww00 ()
Verified purchase
Past 6 months
Reply from: wwww00. Left within past 6 months.
THX for FB. I used these for a Fender Telecaster bass I built w/ OEM '68 Tele neck & tuners and BYO body. Use a 7/64 pilot drill If new instalI. I found the #4 was better than a #3 or a 3mm screws. This is my first sale of the: 16 each pick-guard oval head #4x 3/8" screws also the: 16each #4 tuner round head screws with correct pilot drill. THX again wwww00

NOTE!

Buyer pays shipping via USPS; includes delivery confirmation. Insurance at your option. Shipping worldwide outside contintental USA at your option/peril with additional handling fee from eBay. I accept PAYPAL only held until cleared. There is no reserve! Bidders with negative OR undesirable feedback may be denied participation.
Questions always welcome via e-mail.

Thank You