Our Comp Spec beds are our lightest bed option. Easy to install design simply clamps bed to the factory rear crossmember for a simple yet secure fastening system. Retains factory rear cab mounting setup.

Note: This version uses the factory rear body mounting location, to install the body squeeze in the sides of the body and the back will bow out allowing you to slide it over the post. You will probably find that the rear body pin isn't needed as the bed does a good job securing the body from sliding off of the post.

Narrow Design works great with the Pro-Line Comp Wagon, Jconcepts Anvil, and Reefs RC Plague bodies along with other narrow comp bodies.

Material: ABS plastic

Weight: 35 Grams

Fitment:

• Vanquish® VRD Mullet (with factory chassis rails)

Includes:

• Bed with Fuel Cell (Qty 1)
• Bed Spacer (Qty 1)
• Bed Clamp (Qty 1)
• M3x16 Button Head Screw (Qty 2)

 

3D Printed Product Information

This product is manufactured by us in house using 3D printing. It’s important to understand that 3D printing builds objects layer by layer, which can lead to some inherent characteristics that differ from traditional manufacturing methods:

• Layer Lines: You may observe subtle horizontal lines on the surface of your parts, particularly noticeable on curved or angled surfaces. These are a natural result of the layered printing process.
• Minor Surface Imperfections: Occasionally, small variations in surface texture, sometimes referred to as 'blobs' or 'zits,' may appear. These are often a result of nozzle start/stop points or other minor variations during the printing process. Some part of the parts may have a textured finish on them due to the texture of the 3D print bed itself.
• Support Marks: If the part required any support structures to print correctly, since you cannot print in thin air, their removal can sometimes leave slight marks or rough areas on the surfaces where they were attached. We try to minimize these, and use them only in areas not highly visible.