ENCLOSURE FOR MICROCHIP MPLAB SNAP DEBUG BOARD PG164100 PROTECTIVE BOX

3D PRINTED ENCLOSURE FOR THE PG164100
MICROCHIP MPLAB SNAP IN-CIRCUIT DEBUGGER
Printed in PETG for high durability
as well as moisture and chemical resistance.
Provides access to the PIC/AVR mode jumper,
and resin window for the activity and status leds

The provided pin extender will be very usefull especially on
crowded boards where the MPLAB Snap would have trouble to connect

This easy to assemble enclosure will protect Your hard to get programmer / debugger
from the most common mechanical fault - the micro USB connector breaking off. It also
provides a good level of moisture and dust protection, and will keep Your Snap safe in Your workshop.

Set includes: enclosure front and back, mounting screws, pin extender.
The MPLAB Snap board NOT INCLUDED.

NOTHING ELSE IS INCLUDED.

PLEASE MAKE SURE YOU CAREFULLY READ THE DESCRIPTION
AND CHECK ALL THE PHOTOS


NOTE FOR LISTINGS WITH MORE THAN ONE ITEM AVAILABLE:
ITEMS MIGHT LOOK SLIGHTLY DIFFERENT FROM THE ONE ON THE PHOTO,
BUT WILL HAVE EXACTLY THE SAME SPECS AND PERFORMANCE.
ITEMS WILL BE SENT AT RANDOM.

ITEM CONDITION

REAL ITEM PHOTOS

GENERAL INFORMATION