Our TPMS sensor is including 3 modes: Storage Mode, Driving Mode and Parking Mode.
The TPMS sensor does not send signal at storage mode and parking mode.Only when the driving speed is accelerated, the signal is sent, which is greatly prolongs the product service life!
FITTING INSTRUCTIONS
Every product is fully programmed. Some cars models can be automatically recognized after being installed and driven directly for a certain distance. Some models require machine activation before they can be used.
Learning Process Guide
Position relearn type: OBD relearn.
A proper TPMS tool is required to learn new sensor IDs.
Relearn Procedure:
1.Properly install tire pressure sensors.
2. Ensure all tires are inflated to the pressure listed on the tire placard. (located in the
door jam of your vehicle)
3.Starting with the LF tire, use the TPMS tool to trigger each sensor in the following
order: LF, RF, RR, LR & full size spare (if equipped) .
4. Turn ignition to ON position.
5.Connect TPMS tool to OBD II port then write sensor IDs.
6. Switch off, then switch on the ignition.
7.Test drive above 19 mph (30km/h) for at least 10 minutes, make sure tire pressure
monitor system work fine (TPMS light off) .
]Position relearn type: Automatic relearn.
Relearn Procedure:
1. Inflate all tires to the pressure indicated on tire placard.
2. Turn ignition ON. press ”TRIP“ button for 3 seconds, until INFO Center shows”Reset“.
3. Drive the vehicle to complete relearn.
NOTE: The drive speed should be controlled between 16 mph (25km/h) and 64 mph
（100km/h).