ONE OEM Infiniti LOGO REMOTE 1995 - 1999 Nissan Infiniti 4 Button Keyless Entry Remote Fob - A269ZUA078

Fits:

1995 - 1999 Infiniti I30

1995 - 1999 Nissan Maxima

FCC Number A269ZUA078

OE Part # 28268-40U20

Programming Instructions

1995 Nissan Maxima

 Note: Seat belt must be on during programming procedure.

1.   Close and lock all doors with the driver’s side power lock/unlock

      switch.

2.    Insert key into ignition and remove it from the ignition key cylinder

      at least six times within 10 seconds. Your Hazard Lamps will flash

      if you have performed this step successfully.  ( Withdraw key

      completely from ignition cylinder each time ) . If this procedure is

      performed too fast, system will not enter programming mode.

3.      Insert key into the ignition cylinder and turn to the ACC position.  

4.    Within 5 seconds, push LOCK button on the keyless remote. Your

      Hazard Lamps should flash. ( Do not press the button more than

      one time in the above step). If the button is pressed more than one

      time, the programming procedure will not be successful.   

5.  If there are any remaining remotes (including the old ones), unlock

then lock all doors using the driver’s side power lock/unlock switch

and within 5 seconds, push LOCK button on the next remote. Your

Hazard Lamps should flash. Repeat this step for each keyless remote

(including any existing keyless remotes)

6.  Turn the key to the OFF position, remove keys from the ignition,

Open door, Test Remotes

 

1996 - 1999 Nissan Maxima

1995 - 1999 Infiniti I30

1.     Close and lock all doors with the driver’s side power lock/unlock switch.    

2.    Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds.

      Your Hazard Lamps will flash if you have performed this step successfully.  ( Withdraw key completely from

      ignition cylinder each time ) . If this procedure is performed too fast, system will not enter programming

      mode.   

3.      Insert key into the ignition cylinder and turn to the ACC position.   

4.    Within 5 seconds, push LOCK button on the keyless remote. Your Hazard Lamps should flash. ( Do not press

      the button more than one time in the above step). If the button is pressed more than one time, the

      programming procedure will not be successful.  

5.      If there are any remaining remotes (including the old ones), unlock then lock all doors using the driver’s

      side power lock/unlock switch and within 5 seconds, push LOCK button on the next remote. Your Hazard

      Lamps should flash. Repeat this step for each keyless remote (including any existing keyless remotes).