CNC Stepper Motor Cable 18AWG 4-Wire Ultra Flex 50ft 5 Axis DS Kit

Please review the entire listing, and all videos carefully to understand the gravity of this package.

This listing is for a complete CNC DS Flexion stepper/servo motor cable kit with ground buss for five CNC axis meaning this kit supports five motors, and drives.

If your system is using multiple axes then you will require one of these kits per axis your robot has.

(This kit will allow you build a single motor cable for your CNC robot, and it also includes you're CNC controllers ground buss bar which is required)

This kit includes the following components:

• 50Ft. piece of 18AWG 4 lead Double Shielded DS Flexion Robotics Grade Cable. (This cables outer diameter is 9.3mm with a minimum bend radius of 2.9in)

• 5-GX-16 male "butt" connector (This is to be installed on your motor's leads)

• 10-GX-16 female connectors (This is to be installed on the included DS Flex motor cable)

• 5-GX-16 Pre-wired with18awg silicone leads (this is to be installed in your CNC electronics enclosure)

• 1-tool less mounted ground buss with12 solder type ring connectors (Every CNC controller requires this for proper motor cable shield drain grounding)

• This cable is rated to 600v, and 105 degrees Celsius (221 degrees Fahrenheit), and is designed for applications where an ultra flexible double shielded cable is required. This cable is professional ULTRA FLEX Robotics grade, and features both Mylar foil, and tinned braided copper shielding with integrated yarn separators between each of its four leads.

It also features Integrated shield drain allows for simple grounding.

There's an overview video of DS Flexion Cable below.

The specs below speak for themselves, and remember when comparing other cables on the market to make sure they are double shielded as this is the most effective shielded cable on the market for EMI mitigation.

I can offer this cable in any length single run you require.

Please message me for pricing.

This cable ships UPS for the fastest most economical delivery for US orders for free. If you require expedited shipping please message me.

Please understand there's no warranty on the cable after an end user installs it in their CNC system, as then all cables in your robot are then considered end user consumables as once they've been put in service successfully for any length of time as it's naturally impossible for me to determine its service life based on its installation, usage, servicing ect.

All my international orders are handled through eBay's Global Shipping Program as they offer us both the best protection against loss, and damages. Please review their policy for a shipping quote based on your specific location as they don't disclose it to me.