Features:
Description:
·
Classic & elegant design light up your bathroom’s
practical decoration
o
The universal Tip-Toe bath tub drain stopper brings the most efficient
method to your life - Modern looking and easy installation.
o
It has a metal construction that will endure the rigors of everyday use.
·
EASY TO INSTALL: INSTRUCTIONS:
1. Remove old screws and overflow plate
from the bathtub.
2. Carefully detach plate from linkage
(A) by removing cotter pin (B). Apply to Trip Lever.
3. Attach linkage to new overflow plate
(C). Apply to Trip Lever. Align screw holes (S) on your new overflow plate and
thread screws into place.
4. Remove the old stopper (D). There
are several types of drain stopper, all of which can be removed very easily,
with the stopper in the "open" position by turning the stopper
counter-clockwise until the stopper unthreads from the old one.
5. Remove worn drain body by inserting
plier handles (F) or similar tool into drain, engaging cross members and then
turning counterclockwise to the unthread drain body from the bathtub. Remove
worn drain gasket on the tub (G) if needed.
6. For easy installation, remove the
stopper from new drain first, and then rolling a piece of plumber’s putty in
your hands that are about the same thickness of a pencil. Wrap this underneath
the lip of the new drain body (E), making sure that it reaches all the way
around.
7. Check the size of your bathtub drain
hole.
- For 1-5/8” hole, remove
bushing/adapter (H) from new drain body (E);
- For 1-1/2” hole, keep the bushing/adapter
(H) on new drain body, and firstly place the new gasket (G), if needed, and
then the drain body (E)
in the drain hole. Slowly turn the
drain clockwise to catch the first few threads of the drain elbow underneath
the tub.
***Warning - Careful not to cross
thread.***
8. Once the drain body is carefully
threaded into the first few threads of the drain elbow, use the plier handles
(F) or similar tool to turn clockwise to tighten. The connection needs to be
tight to prevent leaks, but tightening it too much risks cracking the tub or
breaking the seal.
***Warning - Do this carefully, so as
not to squeeze the gasket underneath the tub out of place.***
9. Remove any excess plumber's putty,
and install the tub stopper, if needed. Then plug the tub and run a bit of
water, checking for any leaks.
Package:
·
Tip-Toe bathtub drain kit with drain*1 (1-3/8 in. Npsm (1-5/8 in.
- 16 UNC) fine thread exterior)
·
Solid brass bushing*1(1-1/2 in. Npsm x 11.5 in. Npsm adapter
bushing)
·
One hole overflow faceplate*1
·
Bracket*1
·
Bracket screw*2 (1/4 in.-20 4/5 in)
·
Screws*1(1/4 in.-20 x 2 in.).