eBay

INCLUDES:

1x TPT-500.4 2 Ohm - Timpano Compact 4 Channel TPT-500.4 Car Audio Amplifier

2x TPT-ST3 Black Car Audio Tweeters ( Sold in Pairs ) Total of 4 Units

FEATURES:

TPT-500.4 2 Ohm

Small Footprint Technology! HD Sound Quality!

Timpano amplifiers raises power amplification to a new standard of quality and usability. The new line delivers the most innovative and powerful Brazilian technology in compact full range amplifiers on the market. Loaded with features, it provides an unsurpassed efficiency rate of 80-90% in a compact Class D full range amplifier.

COMPACT DESIGN: Digital class D Brazilian technology allows this amplifier to have a small footprint by integrating a high-speed mosfet power supply with top of line transistors to ensure performance in a small heat sink without compromising performance. Dimensions: 3.93″ depth x 5.02″ width x 2″ height
POWER: This amplifier is designed to run your stereo system with the power it needs to perform! 500 Watts maximum dynamic RMS power output of 4x 125 Watts at 2 Ohm per channel. Its high efficiency rate of 87% provides more power with less battery consumption.
BRIDGEABLE: Double the power output to your speakers by bridging two channels. Minimum impedance of 4 Ohm per bridged channel at output power of 2 x 225 Watts RMS
TECHNOLOGY: A smart electronic 2-way protection circuit protects the amp if it gets too hot or if speakers fail causing a short! Focusing in sound quality, a full range response of 10 to 24,000Hz was used to give the best sound reproduction on this tiny amplifier.
FEATURES: Heavy Duty 10 Gauge power and speaker wire Inputs. Built-in crossover filters for easy tuning! Choose between a fixed HPF at 90Hz or LPF at 90Hz + 45Hz Bass Boost or just turn it FLAT and use your external crossover or DSP settings. It also includes Variable Gain Control. Level controls are not for adjusting volume. They adjust the amount of signal that is coming into the amplifier from your signal source.

Additional Information:

Number of Channels: 4
Max Dynamic Output: 4 x 125 Watts RMS 2 Ohm
4x 100 Watts RMS Power at 2 Ohm 12.6 Volts
4x 50 Watts RMS Power at 4 Ohm 12.6 Volts
Bridged 2x 200 Watts RMS Power at 4 Ohm 12.6 Volts
Supply Voltage: 10 ~ 15V
Frequency Response: 10Hz ~ 24KHz
Crossover Low Pass: Fixed at 90Hz + 45Hz bass boost
Crossover High Pass: Fixed at 90Hz
Signal to Noise: > 90 dB
Harmonic Distortion: < 0.9 % THD
Input Impedance: 20K Ohm
Impedance Output: 2 Ohm
Consumption with Signal Musical: 1A ~ 17A
Dimensions (L x W x H): 3.93” x 5.02” x 2”
Weight: 1.12 Lbs

TPT-ST3 BLACK

Timpano TPT-ST3 BLACK 3.75″ Car Audio Super Bullet Tweeters 600 Watts 4 Ohm – Pair

These tweeters are capable of generating extremely loud volume you need to keep up in the high SPL environment. The aluminum diaphragm has been engineered to take the power needed to keep up and maintain crystal clarity.

CRYSTAL CLEAR HIGHS: These tweeters are capable of generating extremely loud volume you need to keep up in the high SPL environment
BUILT IN CROSSOVER: A capacitor that eliminates out all low end frequencies that might otherwise harm the super tweeters
SHALLOW PROFILE: Featuring a sleek PRO Audio faceplate Design this high performance 3.75 inch round tweeters, only have 1.59 inches of mounting depth.

Engineered and designed in the USA by PRV Audio Group, the TPT-ST3 are car audio high compression bullet tweeters rated at 600 watts max peak power. Ready to deliver major concert sound to your sound system.

Specs:
600 Watts Max Power per pair / 300 Watts each
200 Watts RMS Power per pair / 100 Watts each
Impedance: 4 Ohm each tweeter
Sensitivity: 105 dB
Frequency Response: 2,000 – 22,000Hz
Aluminum Diaphragm with a 1″ voice coil
Replacement Diaphragm: TPT-RPST3
Recommended High Pass Filter on TPT-SP4BT DSP, Based on Power per Tweeter
7500 Hz under 150 Watts of Amplifier RMS Power with 18dB Slope
6000 Hz under 100 Watts of Amplifier RMS Power with 12dB Slope
Sizing:
Mounting Depth: 1.59”
Mounting Cutout Diameter: 2.87″ + Terminals
Overall Size: 3.75′ diameter x 1.80″ Height
Weight: 1.32 Lbs each tweeter
Capacitor attached per tweeter

Quantity: 2 pieces (1 pair)