There are several different products and methods available for filling or darkening the grain on an ash shaft, this is by far the easiest and most effective. This is a quick drying thick liquid formula.

Quick Drying Time

Dries and can be sanded/re-applied usually in around 30mins.

Hard wearing, won’t fall out!

This is solvent based and hard wearing. It will penetrate, cling to and stay in the grain withstanding impact far better than typical off the shelf grain fillers.

Easy to Sand

This solution is easy to layer for deeper grains and also sands easily to achieve a smooth glass like finish over the grain

Long Shelf Life

Stored air tight the mixture won’t dry out or go off.

Application

Before starting WEAR GLOVES to avoid skin contact and wear a face mask throughout, especially when sanding. Make sure the cue is clean and sanded smooth to at least 1200 grit.

·         Shake well before using a clean rag, fine brush or sponge to apply over the grain of the shaft

·         Allow to dry before sanding smooth again in stages from 300/400 grit up to at least 1200

·         Re-apply additional layers if required, for deeper grain fills and repeat the sanding as above (I’d recommend 2000 for a final glass like finish)

·         Finish with several fine coats of cue finishing oil (see my other listings)

Drying times will vary and will ultimately depend on your working environment. Clean brushes/sponges using methylated spirit.

UK postage included. Global shipping please contact first for quote before ordering.