These are a home designed and made to measure set of decals to transform any 1/32 car with a Jagermeister livery.

Consists of Jagermeister logos and symbols in various sizes - symbols range from 25mm to 2mm.

All these sets are all printed using thermal technology so can be used on any colour car. For best results they should be applied to a glossy surface.

Instructions for use:

• Clean the surface where the decal is to be applied. Smooth and glossy is best.
• Cut out your decal carefully, leave a small amount (.5mm) around the design.
• Place the decal in warm water for 20 secs or until it just moves on the backing paper
• Transfer to surface using tweezers and position carefully, using something like a wooden toothpick.
• Roll a cotton bud over the decal to squeeze out any water. Only do this a couple of times.
• Once dry, its recommended to apply a coat of Microscale Micro Gloss or something similar.

Thanks for Looking!