⚡ Original For ROG Harpe Ace Mouse Grip Tape — EVA‑02 Edition
Pre‑Cut / Asuka × Unit‑02 Red‑Black / ~0.75 mm Thin Embossed Anti‑Slip / Fits Harpe Ace Aim Lab + Ace Extreme
✅ Compatible Product
- ROG Harpe Ace Aim Lab Edition
- ROG Harpe Ace Extreme
⚠️ Pre‑cut is model‑locked to full‑size Harpe Ace only. Forcing onto other mice → edge lift, button interference.
📦 Package Contents
- 1 × EVA‑02 Edition Pre‑Cut Grip Tape Set (covers L/R buttons + both side grips)
(No mouse — recommend isopropyl prep before install)
🆚 vs Standard Retail EVA‑02 Tape
🔍 Product Overview
The ROG x Evangelion EVA‑02 / Asuka grip set dresses the Harpe Ace in Unit‑02’s red‑black‑orange scheme with honeycomb tactical texture, Asuka portrait hints, and ROG “For Those Who Dare” marking. This aftermarket version keeps the official die‑cut layout but runs 0.25 mm thinner than typical retail EVA‑02 tape (~0.75 mm vs ~1.0 mm), using a sweat‑absorbing embossed polymer instead of plain rubberized vinyl.
Result: same IP flair, less bulge under the thumb, no click‑feel mush on main buttons.
✨ Key Features
✂️ True Pre‑Cut, No Knife Needed
- Laser‑die‑cut to Harpe Ace Aim Lab shell tolerances.
- Left/right button pieces, two side strips, palm arc (if applicable) — all separated.
- Align → peel → press → done in ~3 min.
🎨 EVA‑02 Unit‑02 Theme
- Red/black base with orange accent stripes (EVA‑02 palette, not generic red).
- Asuka silhouette + “02” marker + honeycomb tactical grid.
- ROG eye logo + “FOR THOSE WHO DARE” printed on side strip.
🪶 0.25 mm Thinner Than Standard
- ROG EVA‑02 tape sits ~1.0 mm; this run is ~0.75 mm.
- Less stack height → main‑click travel feels unchanged, side lift still secure.
- Edges sit flush with shell seam, lower chance of peeling at thumb rest.
💧 Sweat‑Absorb + Anti‑Slip
- Micro‑embossed surface pulls moisture into the matte layer.
- Long ranked sessions: palm/claw/fingertip all stay locked.
- Better than smooth silicone shells or bare coated plastic.
🛡️ Wear Resistant
- Print layer laminated under top matte film → Asuka art doesn’t rub off in 2 weeks.
- Side strips reinforced at thumb/finger contact zones.
⚙️ Technical Specifications
💡 Install Tips
- Clean shell with 70%+ IPA, dry fully — any hand oil kills adhesion.
- Button pieces first: align front nose, press from center outward to push air bubbles to edges.
- Side strips: start at top near L/R, wrap to bottom seam, use thumb nail to seat curve.
- No heat gun — adhesive is tuned for room‑temp press; heat warps thin film.
- If misaligned in first 30 s, peel slowly and re‑seat; after 5 min it’s permanent.
⚠️ Important Notes
- 🔴 Extreme’s carbon weave is smooth/slippery; tape helps grip more there than on Aim Lab matte.
- 🔴 One‑time stick — pulling off destroys adhesive layer, won’t re‑stick cleanly.
- 🔴 Mini/Keris/Gladius owners: don’t “trim to fit”, buy the correct model’s set instead.