NH-1 220V Splicing Press Machine Belt Joiner For Printing Textile Spindle Tape

NH-1 Belt Splicing Hot Press Machine — eBay Full Product Description

1. Product Introduction

NH-1 series portable belt splicer is designed for flat belts and sheet base belts, with a bonding width range of 10mm to 80mm.
 
This handheld joint welder allows on-site splicing of drive belts directly on production equipment, easy to operate with stable performance. It is widely used for thermal bonding of rubber spindle tapes, conveyor belts and nylon sheet base belts.

2. Operation Instructions

  1. Pre-operation Check
     
    Inspect all machine parts for integrity before use. Connect power supply per the rated voltage marked on the nameplate. The red indicator light turns on to show power input, and the green light lights up as the heating plate warms up. The green light will turn off once the temperature reaches 95–105°C, and the temperature can be adjusted up or down as needed.
  2. Belt Bonding Steps
     
    Coat a thin even layer of adhesive on the polished belt joint, then let it air dry for about 10 minutes (adjust time according to your glue type). Clamp the belt joint tightly and place it gently on the heating plate, cover the upper pressure plate and fasten bolts moderately (over-tightening will cause belt offset). Turn on power until the heating lamp goes out, disconnect power, wait for the machine to cool and cure fully, then take out the finished bonded belt.
  3. Temperature Adjustment
     
    A screw knob for temperature control sits inside a small hole on the machine bottom. Rotate clockwise to lower temperature, counter-clockwise to raise temperature.
     
    New machines are factory preset at 95–105°C, no manual adjustment required under normal working conditions.
  4. Hot Splicing Time
     
    Standard heating time ranges from 10 to 30 minutes, depending on the thickness of the belt.
We accept all verified payment from eBay.
1.30 days warranty from the purchased date. Please contact us via email before returning the defective item.

2.Our warranty does not extended to any product that are physically damaged or that are not under normal operating conditions as result of misuse or improper installation on the buyer/user's part.

3.Return items should include the original packaging and all accessories. buyers MUST contact us for the returning address.

4.In all cases, buyers pay shipping fees at their own cost to return products for exchange or refund. We will be responsible for the postage of replacements. Refund will be made upon receipt of the returned item.

 

 

Customer Service -
 
  • Customer services is our main concern as always.
  • We try to accurately describe every piece to the best of our knowledge.
  • Feedback will be posted right away after the item has been shipped.
  • If you are any issue or problem please send us a message, we will do our best to resolve the issue
  • Before you leaving us any negative or neutral feedback.
  • Thank you for visiting our eBay store!
Pls contact us if you have any problems,we will try our best to solve for you.
PushAuction