A 30-piece press and pull sleeve kit for removing and installing bearings, bushes and seals across a wide range of workshop and vehicle repair jobs. It is suited to work on silent bearings, hydro bearings, bushings, ball bearings, simmer rings, shaft seals and rubber bearings where controlled fitting or removal is needed.

Used for garage work, servicing and general repair tasks, this set helps when working on components that need pressing in or pulling out without relying on improvised tools. It suits mechanics, engineers and experienced DIY users carrying out bearing replacement, bush removal, seal fitting and similar maintenance jobs on vehicles and machinery. The range of sleeves and pulling spindles makes it useful when different sizes come up regularly during workshop use.

The set includes 20 press sleeves covering inside diameters from 34mm to 72mm, with outside diameters from 44mm to 82mm, giving a broad spread for common bearing and bush sizes. Four pulling spindles with nuts are included in M10, M12, M14 and M16 sizes, along with four stop plate discs matched to specific sleeve groups. This layout helps keep the right combination close at hand when moving between different fitting and removal jobs, which is useful for regular maintenance and repeated workshop use.

• Contents: 30-piece set with 20 press sleeves, 4 pulling spindles with nuts and 4 stop plate discs.
• Sleeve range: Inside diameters from 34mm to 72mm to cover a wide selection of bearing, bush and seal jobs.
• Outside sizes: Sleeve outside diameters run from 44mm to 82mm.
• Spindle sizes: Includes M10, M12, M14 and M16 pulling spindles with nuts.
• Application: Suitable for installation and removal of silent bearings, hydro bearings, bushings, ball bearings, simmer rings, shaft seals and rubber bearings.

A practical choice for regular maintenance and repair work.