1MHz-200MHz RF Broadband Power Amplifier 50W RF Wideband Power Amplifier AMP
This amplifier adopts the latest imported amplifier tubes, which have the characteristics of wide frequency range, high output power, and high power efficiency. The efficiency value can reach 65% and can be used for power amplification of 1M-200MHz signals.
Parameter:
Frequency range: 1M~200MHz
Output power: 25~50W
Amplification gain: 35dB
Supply voltage: 46~56V
Maximum output: 47dBm (50W)
Maximum input: 20dBm
Maximum operating temperature: 50 ° C
Power supply current: 1-1.5A
System impedance: 50 Ω
Load standing wave: less than 2.5
Product weight: 620g
Dimensions: 130 * 110 * 45mm (excluding joints)
Type of connector: SMA female head (outer screw inner hole)
Package Include:
1 x RF Amplifier
Note:
1. Before use, all instruments and equipment should be grounded together (without any potential difference), and then connected with RF cables. The load must be connected and it is strictly prohibited to use them without load, especially for power amplifiers.
2. It is necessary to use a "legitimate" antenna, especially when using the antenna as a load, to ensure that the impedance of the antenna matches within the operating frequency (generally requiring a voltage standing wave ratio of less than 2.0). It is strictly prohibited to use "illegitimate" antennas, such as rod antennas, copper wire antennas, and cheap antennas, which have no definite impedance.
3. Use linear power supplies as much as possible, especially when using low-noise amplifiers, be sure to use linear power supplies or batteries. Switching power supplies themselves have a lot of noise, which can enter the amplification circuit. Do not use switching power supplies.
Parameter:
Frequency range: 1M~200MHz
Output power: 25~50W
Amplification gain: 35dB
Supply voltage: 46~56V
Maximum output: 47dBm (50W)
Maximum input: 20dBm
Maximum operating temperature: 50 ° C
Power supply current: 1-1.5A
System impedance: 50 Ω
Load standing wave: less than 2.5
Product weight: 620g
Dimensions: 130 * 110 * 45mm (excluding joints)
Type of connector: SMA female head (outer screw inner hole)
Package Include:
1 x RF Amplifier
Note:
1. Before use, all instruments and equipment should be grounded together (without any potential difference), and then connected with RF cables. The load must be connected and it is strictly prohibited to use them without load, especially for power amplifiers.
2. It is necessary to use a "legitimate" antenna, especially when using the antenna as a load, to ensure that the impedance of the antenna matches within the operating frequency (generally requiring a voltage standing wave ratio of less than 2.0). It is strictly prohibited to use "illegitimate" antennas, such as rod antennas, copper wire antennas, and cheap antennas, which have no definite impedance.
3. Use linear power supplies as much as possible, especially when using low-noise amplifiers, be sure to use linear power supplies or batteries. Switching power supplies themselves have a lot of noise, which can enter the amplification circuit. Do not use switching power supplies.
